Home

How Do You Use the Clutch Without Stalling the Car?

To use the clutch without stalling, select first gear, press the accelerator gently and raise the clutch slowly through its biting point until the car moves. As you gain speed, release the clutch fully. When stopping, press it down before the engine begins to struggle.

Why does your car stall?

The clutch connects the running engine to the gearbox and disconnects it when needed. When you press the pedal fully down, you disconnect them; as you release it, you gradually transfer power to the wheels.

If you release the clutch too quickly when moving off, the engine suddenly has to move the car's weight. Without enough engine speed, it can stop running. You can also stall if you select too high a gear at low speed or brake to a stop without pressing the clutch.

Aim for a controlled clutch release, rather than simply moving your foot as slowly as possible. Release the pedal steadily as the clutch engages, then fully once the car is moving comfortably.

How do you find the clutch biting point?

The biting point is the pedal position where the clutch starts transmitting enough power for the car to pull forward. Its position varies between cars, so find it whenever you drive an unfamiliar manual car.

Practise on level ground in a traffic-free area where you have permission to drive, with a qualified instructor. Adjust your seat so you can press the clutch fully without stretching your leg, while keeping a slight bend in your knee.

Select first gear and secure the car with the parking brake. Following your instructor's directions, slowly raise the clutch. You may hear the engine note change, see the rev counter dip slightly or feel the car begin to pull. Once you recognise that point, press the clutch down again rather than holding it there against the brake.

You can move some cars on level ground with little or no pressure on the accelerator; others need more. Don't assume the same technique will work in every car.

How do you use the clutch when moving off?

Begin on level ground before practising on slopes or at busy junctions. Wear secure footwear that lets you feel the pedals. Use your left foot for the clutch and your right foot for the accelerator and brake.

  1. Press the clutch fully down and select first gear, keeping the car stationary with the brake.
  2. Check your mirrors, surroundings and blind spots, and signal if necessary.
  3. Press the accelerator gently to produce a steady, slightly raised engine note. Avoid revving hard.
  4. Raise the clutch to the biting point, timing your brake release so the car cannot roll unexpectedly.
  5. As the car starts moving, briefly hold your clutch foot steady and maintain gentle pressure on the accelerator.
  6. Continue releasing the clutch smoothly as you gain speed, then move your left foot onto the footrest.

If the engine note drops sharply or the car shudders, press the clutch down slightly and press the accelerator a little more if it's safe to continue. Don't suddenly release the clutch the rest of the way. If the car surges forward, ease off the accelerator rather than moving the clutch abruptly.

When should you press the clutch?

For a normal stop, ease off the accelerator and brake progressively while staying in gear. Press the clutch fully down as you slow to the point where the engine would struggle, then finish braking. Don't wait until the car shudders heavily.

There's no single road speed at which you should press the clutch. The right point depends on your gear, the car and the load it carries. During low-speed manoeuvres, you may need to press it sooner because you're already close to the lowest speed the engine can sustain smoothly in that gear.

To change gear, ease off the accelerator, press the clutch fully down and select a suitable gear. Release the clutch smoothly while pressing the accelerator again as needed. Avoid selecting a high gear before you have enough speed for the engine to pull comfortably.

Don't keep the clutch down throughout a long approach to a junction. If you do, you're coasting, which removes engine braking and can reduce your control, as explained in the Highway Code.

How do you avoid stalling in traffic or on hills?

In slow traffic, leave enough space to move forward steadily rather than repeatedly moving a few centimetres. Use first gear at walking pace. If traffic stops, press the clutch fully down and brake. For a longer wait, select neutral and secure the car with the parking brake.

For very slow manoeuvres, you may need to keep the clutch partly engaged for short periods. Do this briefly and with control. When you need to stop, press the clutch down and brake rather than continuously revving the engine with the clutch partly engaged.

For an uphill start, use the parking brake to prevent rollback. Select first gear, press the accelerator enough for the slope and raise the clutch until you feel the car ready to pull. Check that it's safe, release the parking brake and gradually release the clutch as you move forward.

You'll usually need more engine power to move uphill than on level ground. Never hold the car stationary on a slope using the clutch and accelerator, as this generates heat and increases clutch wear. If your car has hill-start assistance or an electronic parking brake, ask your instructor to show you how it works.

What should you do if the car stalls?

Secure the car first by pressing the clutch fully down and applying the brake. Use the parking brake if needed, select neutral and restart according to your vehicle's instructions. Check your surroundings again before selecting first gear and moving off. Don't rush because another driver sounds the horn.

To stall less often and avoid unnecessary clutch wear, follow these habits:

  • Use first gear when moving off from a standstill normally.
  • Keep your foot off the clutch pedal once you've finished changing gear.
  • Use the brakes, not a partly engaged clutch, to keep the car stationary.
  • Practise finding the biting point with an instructor before trying slopes or heavier traffic.

If the engine repeatedly cuts out despite correct pedal control, or the clutch judders strongly, smells burnt or engages unpredictably, stop practising and have a qualified mechanic inspect the car.

Sources